34 11 Front Brake
FRONT BRAKE SPECIFICATION
|
IMPORTANT:
New brake pads may only be fitted if the brake disc thickness is greater than the minimum brake disc thickness (MIN TH).
Minimum brake disc thickness during general inspection (GI): Nominal size thickness minus 2.4 mm (Not applicable to perforated brake discs) Perforated brake discs: Nominal size thickness minus 1.6 mm Depending on:
different brake discs can be fitted The brake discs must always be assigned by way of the relevant vehicle identification number. |
||
| Different thicknesses on brake linings | Max. mm | 0.01 |
| Surface roughness of braking surfaces (precision-turned) | Ra μ | 0.5... 3.5 |
| Max. machining dimension per friction ring side (perforated brake discs must not be machined). Brake disc minimum thickness (MIN TH) must not be undershot. |
mm | 0.8 |
| Nominal size (diameter x thickness) | mm | 316x22 |
| Nominal size (diameter x thickness) | mm | 294x22 |
| Nominal size (diameter x thickness) | mm | 280x22 |
| Brake disk minimum thickness (MIN TH) stamped on brake disk body | mm | 20.4 |
| Wear warning from residual lining thickness | mm | 3.7 |