37 14 511 Replacing front ride-height sensor

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

NOTE: Jointed rod to holder 37 14 4AZ .
Holder to control arm 37 14 5AZ .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release screw (1).

Remove holder for ride-height sensor from front axle carrier and disconnect plug connection (3).

Installation:

Sensor lever (2) must point from ride-height sensor to left front wheel.

Tightening torque 37 14 2AZ .

Release nut (4) and remove jointed rod from sensor lever (2).

Fig 1: Identifying Sensor Lever, Plug Connection, Screw, And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace self-locking nut.

Tightening torque 37 14 4AZ .

Installation:

Align ride-height sensor holder by means of lug (1) to opening (2) in front axle carrier.

Fig 2: Aligning Sensor Holder By Means Of Lug To Opening In Front Axle Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove ride-height sensor (2).

Tightening torque 37 14 1AZ .

Fig 3: Identifying Ride-Height Sensor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: