52 26 022 Removing and installing striker for left or right rear seat back
Necessary preliminary tasks:
- Move backrest back
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Remove cover from lock striker.
Release screws (1).
Tightening torque: 52 26 04AZ .
Remove striker (2).
Installation:
Adjust STRIKER (2).