51 14 012 Removing and installing/replacing rear MINI badge

Special tools required:

00 9 322

IMPORTANT: The INSTRUCTIONS on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

Removing badge:

Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322 .

Fig 1: Removing MINI Badge Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Fitting badge:

Pull liner off adhesive tape (1), position badge over guide pins (2) on rear lid and press down firmly.

Liner is the protective film on a new badge.

Fig 2: Identifying Adhesive Tape And Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.