37 14 511 Replacing front ride-height sensor

IMPORTANT: Observe safety instructions for raising the vehicle, see LIFTING VEHICLE WITH A LIFTING PLATFORM .

NOTE:

Tightening torques:

IMPORTANT: Read and comply with NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)

Release bolt (1).

Remove holder for ride-height sensor from front axle carrier and disconnect plug connection (3).

Installation:

Sensor lever (2) must point from ride-height sensor to left front wheel.

Tightening torque: 7.6 Nm

Release nut (4) and remove jointed rod from sensor lever (2).

Installation:

Replace self-locking nut.

Tightening torque: 7.2 Nm

Fig 1: Sensor Lever And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Align ride-height sensor holder by means of lug (1) to opening (2) in front axle carrier.

Fig 2: Axle Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove ride-height sensor (2).

Tightening torque: 4.4 Nm

Fig 3: Ride-Height Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: