18 31 Exhaust system, complete
WARNING: This page is about a different variant/trim than selected.
EXHAUST SYSTEM, COMPLETE TIGHTENING TORQUES
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Catalytic exhaust-gas converter to turbocharger | N14 | M8 | Initial tightening | 7 Nm |
| Final tightening | 40 ± 6 Nm | |||
| 2AZ Stud to turbocharger | N14 | M8 | 10 Nm | |
| 3AZ Catalytic converter to bracket | N14 | M8 | Replace nuts | 20 ± 5 Nm |
| 4AZ Bracket, catalytic converter, to crankcase | N14 | M8 | 20 ± 5 Nm | |
| 5AZ V-band clamp, exhaust system, to catalytic converter | N12, N14 | 25 ± 3 Nm | ||
| 6AZ Clamp | N12, N14 | 45 Nm |