51 43 251 Removing And Installing/Replacing Trim Panel For Left Or Right Rear Roof Pillar (C-Pillar)

WARNING: Vehicles with head airbags:
Read and comply with safety regulations for working on vehicles with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove the trim (risk of damage to head airbag).

Lever out cap (1) and release screw underneath.

Tightening torque: 2 Nm

Detach panel (2) from clips (4) towards inside.

Only if replacing, release belt strap (3) (see last work step).

Installation:

If necessary, replace faulty clips (4).

Make sure seal for rear lid is correctly seated.

Fig 1: Identifying Cap, Panel, Belt Strap And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Secure head airbag (1) to clip (2).

Place panel (3) with clips and guide (4) on roof pillar and clip into place.

Fig 2: Identifying Head Airbag, Clip, Panel And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screw.

Tightening torque: 36 Nm

Feed out belt strap from trim panel for roof pillar.

Fig 3: Locating Screw

Courtesy of BMW OF NORTH AMERICA, INC.