66 12 100 Removing and installing (replacing) slide-in unit for radio-operated key (start/stop switch)

Special tools required:

IMPORTANT:

In the event of complaint "slide-in unit for radio-operated key jams or can not be retained", carry out following checks before replacement:

Check both sides of plug connection of ribbon cable (1) to slide-in unit for radio-operated key (4) for correct locking (3).
Check ribbon cable (2) for damage.

If required, lock plug connection of ribbon cable (1) correctly and carry out function check.

If this rectifies fault pattern, do not replace slide-in unit for radio-operated key.

Fig 1: Checking Ribbon Cable And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Lever out trim (1) with special tool 00 9 340 at retaining points (2) in direction of arrow.

Fig 2: Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove slide-in unit for radio control key (2).

Fig 3: Screws And Radio Control Key

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure clasps (1) are correctly seated, replace if necessary.

Fig 4: Clasps

Courtesy of BMW OF NORTH AMERICA, INC.