51 23 212 Removing And Installing/Replacing Cable For Front Engine Hood/Bonnet Locks (In Passenger Compartment)

Necessary preliminary tasks:

Disengage cable (1) at lever (2).

If necessary, disengage cable (1) at guide clips up to bulkhead.

Fig 1: Identifying Cable And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out coupling (1) and open.

Disengage cable (2).

Fig 2: Identifying Coupling And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Feed cable (1) out of front bulkhead (2).

Feed cable (1) with grommet (3) out of rear bulkhead.

Installation:

Make sure grommet (3) is correctly seated on rear bulkhead.

Fig 3: Identifying Cable, Front Bulkhead And Grommet

Courtesy of BMW OF NORTH AMERICA, INC.