51 11 050 Removing And Installing/Replacing Support For Front Bumper Panel
Special tools required:
- 00 2 271
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL .
NOTE:
The operation is described on the right side; proceed in the same way for the left side.
The position of the front panel is not altered by special tool 00 2 271.
Therefore no adjustment work is required.
The position of the front panel is not altered by special tool 00 2 271.
Therefore no adjustment work is required.
Insert special tool 00 2 271 and screw down.
If necessary, release cable holder (1).
Unfasten screws (2 and 4).
Release nuts (3) and remove carrier.
Installation note:
Make sure foam part is correctly positioned on support.
Tightening torque: 22 Nm