Preparation of new part

Mark severance cut (1) on new part in accordance with shape of side panel and cut.

Severance cut (2) of rear trim panel on car.

Open weld joints and remove component (3).

Fig 1: Identifying Severance Cut Of Rear Trim Panel And Welded Joint

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust rear trim panel to fit and secure.

Set eleven 4.2 mm dia. holes for blind rivets in areas (1).

Remove new part again and deburr holes.

Fig 2: Identifying Holes For Blind Rivets Areas

Courtesy of BMW OF NORTH AMERICA, INC.