41 33 040 Replacing Front Wall

Refer to relevant service information in BODY, GENERAL .

The graphics are schematic representations and are to be applied to the relevant vehicle type.

The following new body parts are required:

(1) Lock bridge
(2) Front panel

Fig 1: Identifying Lock Bridge With Front Panel
Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on both sides of vehicle.

Tightening torque, see 51 71 7AZ .

Release screws (2) on both sides of vehicle.

Tightening torque: 8 Nm.

Fig 2: Identifying Screws On Both Sides Of Vehicle

Courtesy of BMW OF NORTH AMERICA, INC.