65 83 590 Removing and installing/replacing gyro sensor drive for Car Communication Computer

Necessary preliminary tasks:

If necessary, cut through warranty seal.

Release screws (1).

Remove floor pan (2) towards bottom and set down.

IMPORTANT: Contact spring strip (3) on floor pan (2) must not be bent: otherwise risk of short-circuiting!

When reinstalling floor pan (2), make sure individual springs of contact spring strip (3) are correctly seated.

Fig 1: Floor Pam, Screws And Contact Spring Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Detach gyro sensor for Car Communication Computer (2) in direction of arrow from plug-in contact (3).

Fig 2: Car Communication Computer, Screw, Plug-In Contact And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.