65 83 580 Removing and installing/replacing DVD drive for Car Communication Computer

Special tools required:

00 9 450
12 7 192
64 1 020

IMPORTANT: Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection).

Risk of damage!

Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and earth/ground.

Necessary preliminary tasks:

Remove front trim for Car Communication Computer

If necessary, cut through warranty seal.

Raise cover (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).

Fig 1: Cover, Car Communication Computer, Special Tool (64 1 020) And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Feed out bridge (2).

Installation:

Use special tool 00 9 450 to tighten down screws.

Tightening torque: 0.4 Nm.

Fig 2: Mounting Screws And Bridge

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through stickers at marked points (1).

Release screws (2) and remove trim (3).

Installation:

Use special tool 00 9 450 to tighten down screws.

Tightening torque: 0.4 Nm.

Fig 3: Marked Points, Screws And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) with magnetic screwdriver.

Installation:

Lug (2) of DVD drive must be above lug (3) of Car Communication Computer.

Fig 4: DVD Drive Screws And Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Turn Car Communication Computer through 180° and carefully feed out DVD drive.

Carefully disconnect plug connections (1, 2).

Remove DVD drive (3).

Installation:

Ensure correct cable routing.

Fig 5: Plug Connections And DVD Drive

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

On cars manufactured before March 2006 it is essential after replacing the DVD drive to carry out a measures plan or a software update as per SSS/Progman/CIP.