61 62 100 Adjusting Washer Jet For Rear Window Washer System (Version 2)
NOTE:
Rear wiper must be in rest position.
Mark the contact point (1) with adhesive tape (A=55 mm / B=490 mm).
Operate the window washer system.
The spray jet must hit the mark.
If necessary, adjust the washer jet (3).
IMPORTANT:
Do not insert pointy objects into the washer jet (3) (risk of damage).
Open protective cap (2).
Use a suitable tool to adjust the washer jet (3) until the spray jet hits the mark.
If applicable, remove adhesive residue from the rear window.
Fill up with washer fluid.