65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

Necessary preliminary tasks:

Unscrew nuts.

Remove holder with pitch sensor and disconnect associated plug connection.

Fig 1: Identifying Nuts And Pitch Sensor Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release nut (1) and remove tilt alarm sensor from holder.

Tightening torque: 7 Nm

Installation note:

Make sure tilt alarm sensor is correctly seated in holder.

Fig 2: Identifying Nut And Pitch Sensor Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: