65 77 532 Removing and installing/replacing front left acceleration sensor (US version only)

Necessary preliminary tasks:

Remove WHEEL ARCH COVER at front.

Disconnect plug connection (1).

Release screws (2) and remove acceleration sensor (3).

Installation note:

Replace screws (2).

Tightening torque 65 77 4AZ .

Fig 1: Identifying Plug Connection, Screws And Acceleration Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The installation position of the acceleration sensor has been changed on vehicles built after 08/2010:
(1) Installation position before 08/2010
(3) Installation position after 08/2010
The acceleration sensor (3) is positioned slightly offset on the other side of support (2).

Fig 2: Installation Position Of Acceleration Sensor With Support

Courtesy of BMW OF NORTH AMERICA, INC.