65 20 022 Removing and installing/replacing roof mounted aerial/antenna
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection)
.
Necessary preliminary tasks:
- Lower Roofliner
Disconnect plug connection (1).
Disconnect plug connection (1).
Release retainer (2) and feed out roof antenna with leads towards top.
Tightening torque 65 20 1AZ .
NOTE:
Roof antenna shown removed for purposes of clarity.
Installation:
Ensure correct cable routing.
Feed antenna leads (1) through groove (2).
Tab (3) when installed secures antenna leads.
Installation:
Make sure guide (1) is correctly seated in roof opening (2).
Seal (3) must not be damaged.
Align roof antenna to car longitudinal axis.