66 20 517 Removing and installing/replacing a front center left ultrasonic sensor (S63)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL .
Unfasten plug connection (1) and disconnect.
Unclip ultrasonic sensor (2) from retaining tabs.
Installation note:
Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Retaining tabs must not be damaged.
Make sure ultrasonic transducer (2) is securely seated.
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).