66 31 010 Instructions for ACC adjusting device

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This service information is valid for the entire F-series with the new ACC sensor.

Fig 1: Identifying Measurement Area For ACC Adjusting Device

Courtesy of BMW OF NORTH AMERICA, INC.

Requirements for the measurement area for ACC adjusting device

Dimensions:

Area behind the mirror of at least 80 cm that cane be entered
Distance between mirror and vehicle 80 cm +/- 5 cm
(Distance between mirror and ACC sensor 100 cm +/- 5 cm)
Total area of work area 360 cm x 660 cm

Maximum irregularity of floor surface:

Floor surface - adjusting device ≤ 1 mm
Floor surface - vehicle ≤ 10 mm

Fig 2: Identifying Maximum Angle Of Inclination Of Floor Surface - Vehicle
Courtesy of BMW OF NORTH AMERICA, INC.

Maximum angle of inclination of floor surface - vehicle:

Downward incline of floor surface maximum 3°, see Fig 2 above (1)
Upward incline of floor surface maximum 1°, see Fig 2 above (2)

NOTE: Setting up the ACC adjusting device (one-off task) comprises the following steps:

Assembly of adjusting device
Assembly of rail
Basic setting of adjusting device on measurement area

Detailed setup and operating instructions are enclosed with every ACC adjusting device .