31 12 130 Replacing rubber mount in left or right control arm

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

IMPORTANT: Mark alignment of rubber mount to bracket prior to removal.

Fig 1: Identifying Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Press out rubber mount with special tool 31 5 150 as shown.

Fig 2: Identifying Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Arrow on rubber mount must point to marking on bracket.

Fig 3: Identifying Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Press in rubber mount with special tool 31 5 150 as shown.

Fig 4: Identifying Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.