31 35 021 Replacing both rubber mounts for anti-roll bar mounting on front axle support

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

IMPORTANT: Circo Light must not be used between anti-roll bar and rubber mount!

Remove retaining brackets (1).

Remove rubber mount (2) from anti-roll bar (2).

Installation note:

Keep anti-roll bar clean and free of oil and grease.

Make sure rubber mount (2) is correctly engaged on locating ring (3).

To install retaining bracket (1), coat rubber mount with Circo Light (sourcing reference: BMW Parts Service).

Fig 1: Identifying Retaining Brackets, Rubber Mount And Anti-Roll Bar

Courtesy of BMW OF NORTH AMERICA, INC.