25 11 071 Replacing knob for shift lever

WARNING: This page is about a different variant/trim than selected.

Pull gaiter (1) forwards at an angle.

Using a suitable tool, release retaining lugs of retaining ring (2).

NOTE:

Do not twist knob during removal as this would cause the turning lock in the knob to shear off.

Tug firmly to remove knob.

Installation:

Fit knob on shift lever, align and press on until it snaps noticeably into place.

Fig 1: Releasing Retaining Lugs Of Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Pull gaiter over shift lever knob.

Release retaining lugs (1).

Detach gaiter (2) from shift lever knob.

Fig 2: Identifying Retaining Lugs And Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Note installation position.

Distance between retaining lugs (1/2) differs in size.

Fig 3: Identifying Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.