24 12 110 Removing and installing/replacing selector shaft radial seal (AISIN)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 24 4 280
- 24 4 290 . See AUTOMATIC TRANSMISSION - SPECIAL TOOLS -- S CLUBMAN .
Necessary preliminary tasks:
- Remove gear position switch
Screw special tool 24 4 280 firmly into radial shaft seal.
Pull seal out of transmission case by means of bolt (1).
Installation:
Coat sealing lips of new radial seal with clean transmission oil.
Drive shaft seal firmly home with special tool 24 4 290.