24 21 230 Removing radial shaft seal of right axle shaft (AISIN)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 23 0 490 . See MANUAL TRANSMISSION - SPECIAL TOOLS -- S CLUBMAN .
- 24 4 300 . See AUTOMATIC TRANSMISSION - SPECIAL TOOLS -- S CLUBMAN .
Necessary preliminary tasks:
- Drain off transmission oil.
- Remove right axle shaft. See 31 60 004 REMOVING AND INSTALLING / REPLACING RIGHT OUTPUT SHAFT .
Drive a hole into radial shaft seal using a center punch.
IMPORTANT:
Do not use a drill as drillings may result in transmission malfunction.
Screw special tool 23 0 490 into radial shaft seal.
Drive out radial shaft seal (1) with impact weight (2).
Installation:
Coat sealing lips of new radial seal with clean transmission oil.
Drive radial shaft seal (1) firmly home with special tool 24 4 300.