13 90 500 Replacing tank venting valve (N14)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Installation location:

Tank vent valve is fitted at bottom on INTAKE MANIFOLD .

Unlock and disconnect line (1).

Unclip line (2) from holder (3).Unlock line (2) and detach from intake manifold.

Detach tank venting valve (4) from holder until plug is accessible. Detach plug and remove tank venting valve (4).

Fig 1: Detaching Tank Venting Valve From Holder Until Plug

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Read out fault memory of DME control unit.
Now clear the fault memory.