84 11 519 Removing and installing/replacing eject box

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Disconnect plug connection (1).

Unclip plug housing (2) and disconnect plug connection (3).

Expose connecting line up to eject box.

Fig 1: Identifying Plug Connection And Plug Housing

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, press button (1) and remove cover (2).

Release screw (3) with T10 Torx screwdriver.

Raise cover (4) at front and remove towards rear.

Installation:

Replace damaged cover.

Make sure cover is correctly positioned.

Fig 2: Raising Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Snap eject box (1) out of Centre armrest on both sides using special tool 00 9 340 .

Remove eject box (1) and feed out connecting line.

Fig 3: Identifying Eject Box With Special Tool 00 9 340

Courtesy of BMW OF NORTH AMERICA, INC.