11 12 Cylinder Head with Cover
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUES SPECIFICATION - CYLINDER HEAD WITH COVER
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Cylinder head bolts | N12 | M8x95 | Replace screws | |
| Jointing torque | 15 Nm | |||
| 1st angle of rotation | 90° | |||
| 2. Angle of rotation | 90° | |||
| 2AZ Cylinder head bolts | N12 | M10x145 | Replace screws | |
| Jointing torque | 30 Nm | |||
| 1st angle of rotation | 90° | |||
| 2. Angle of rotation | 90° | |||
| 3AZ Cylinder head bolts | N12 | M8x35 | Replace screws | 30 Nm |
| 4AZ Cylinder head cover to cylinder head | N12 | M6x30 | 10 Nm | |
| 5AZ Ground cable to cylinder head cover | N12 | M5 | 10 Nm | |
| 6AZ Bearing block of eccentric shaft to cylinder head | N12 | M6x40 M6x70 |
10 Nm | |
| 7AZ Inlet camshaft bearing cap to bearing block | N12 | M6x30.5 | 10 Nm | |
| 8AZ Exhaust camshaft bearing cap to cylinder head | N12 | M6x40 | 10 Nm | |
| 9AZ Lifting lug to cylinder head | N12 | M8x20 M8x25 |
20 Nm | |
| 10AZ VVT sensor to cylinder head | N12 | M6x40 | 10 Nm | |
| 11AZ Acoustic cover to cylinder head cover | N12 | M6x40 | 8.5 Nm |