11 21 Crankshaft and Bearings
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUES SPECIFICATION - CRANKSHAFT AND BEARINGS
| |
Type |
Thread |
Tightening specification |
Measure |
1AZ Torsion damper (hub) to crankshaft
(central bolt) |
N12 |
M14 x1.5 x74 |
Replace screws
Lightly oil screws and threads |
|
| |
|
|
Jointing torque |
50 Nm |
| |
|
|
Torque angle |
100° |