18 00 020 Removing and installing complete exhaust system (N12)

WARNING: This page is about a different variant/trim than selected.

WARNING: Danger of burning and other injuries!
These tasks should only be carried out on an exhaust system that has cooled down.
Removal of the exhaust system must be carried out with the assistance of a second person.

Unfasten clip.

Tightening torque 18 31 5AZ

Fig 1: Locating Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Spray rubber mount (1) with antiseize agent and detach from rear muffler (2).

NOTE: Illustration shows and text refers to the right rubber mount.

The procedure is identical for the left side.

Fig 2: Mount And Rear Muffler

Courtesy of BMW OF NORTH AMERICA, INC.

Spray rubber mount (1) with antiseize agent and detach from exhaust pipe (2).

Fig 3: Rubber Mount And Exhaust Pipe

Courtesy of BMW OF NORTH AMERICA, INC.

Support exhaust system with a suitable lifter.

Release screws and remove cross-brace (1).

Lower and remove exhaust system with assistance of a second person.

Fig 4: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check rubber mount for damage, replace if necessary.