65 83 580 Removing and installing/replacing DVD drive for Car Communication Computer

WARNING: This page is about a different variant/trim than selected.

Special tools required:

00 9 450
12 7 192 . See.
64 1 020 . See.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
Risk of damage!
Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and earth/ground.

Necessary preliminary tasks:

Remove front trim for Car Communication Computer .

If necessary, cut through warranty seal.

Raise cover (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).

Fig 1: Raising Cover With Special Tool 64 1 020

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Feed out bridge (2).

Installation:

Use special tool 00 9 450 to tighten down screws.

Tightening torque 65 52 1AZ .

Fig 2: Identifying Bridge

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through stickers at marked points (1).

Release screws (2) and remove trim (3).

Installation:

Use special tool 00 9 450 to tighten down screws.

Tightening torque 65 52 1AZ .

Fig 3: Identifying Trim Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) with magnetic screwdriver.

Installation:

Lug (2) of DVD drive must be above lug (3) of Car Communication Computer.

Fig 4: Identifying Lug Of DVD Drive And Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.

Turn Car Communication Computer through 180° and carefully feed out DVD drive.

Carefully disconnect plug connections (1, 2).

Remove DVD drive (3).

Installation:

Ensure correct cable routing.

Fig 5: Identifying Plug Connections And DVD Drive

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: There are two versions of the plug connection (2) shown in image R65 0952: Previous version (1): ribbon cable is connected horizontally Current version (2): ribbon cable is connected vertically

Fig 6: Identifying Ribbon Cable Connection Horizontally And Vertically

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

On cars before March 2006 it is essential after replacing the DVD drive to carry out a measures plan or a software update as per SSS/Progman/CIP .