54 13 090 Removing and installing/replacing wind deflector

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1).

Fig 1: Identifying Wind Deflector Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The right side is removed in the same way as the left side.

Press retaining lugs and slide spring joint (1) forwards up to opening in rail profile.

Remove spring joint towards top from rail profile.

Installation:

Make sure rail profile is at correct installed height.

Fig 2: Removing Spring Joint Toward Top From Rail Profile

Courtesy of BMW OF NORTH AMERICA, INC.