52 13 010 Removing and installing/replacing both seat rails on left or right front seat

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Disconnect Bowden cable (1).

Unclip Bowden cable sleeve from holder.

Fig 1: Disconnecting Bowden Cable (1)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Screws (1)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 3: Identifying Screws (1)

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out locking clip.

Remove seat rail from adjusting bracket (1) and unlocking linkage (2).

Installation:

Unlocking linkage must rest on locking pawl.

Fig 4: Removing Seat Rail From Adjusting Bracket (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out locking clip.

Remove seat rail from adjusting bracket (1) and unlocking linkage (2).

Installation:

Unlocking linkage must be attached to pin.

Fig 5: Removing Seat Rail From Adjusting Bracket (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.