51 13 124 Removing and installing/replacing right cowl panel cover

WARNING: This page is about a different variant/trim than selected.

Remove gasket (1).

Release nut (2) and screw (3).

Unclip cover (4) towards top from retaining strip (5) and feed out.

Installation:

Make sure cover (4) is correctly seated on retaining strip (5).

Fig 1: Removing Cover From Retaining Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seals (1) on cover (2) must not be damaged.

Fig 2: Identifying Seals And Cover

Courtesy of BMW OF NORTH AMERICA, INC.