51 22 010 Replacing top clubdoor detent (striker)

WARNING: This page is about a different variant/trim than selected.

Pull off striker cover (1).

If necessary, detach mucket (3) in working area.

Installation:

Retaining lugs (2) must not be damaged.

Make sure mucket (3) is correctly seated.

Fig 1: Identifying Striker Cover, Lugs And Mucket

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove cover (2).

Fig 2: Identifying Screws And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove door detent (2).

Tightening torque 51 22 1AZ

Installation:

Labelling (3) of striker must point in direction of travel.

Fig 3: Identifying Striker Labelling, Screws And Door Detent

Courtesy of BMW OF NORTH AMERICA, INC.