51 16 026 Replacing mirror glass

WARNING: This page is about a different variant/trim than selected.

Special tools required:

00 9 317

WARNING: Move mirror glass with hand carefully and slowly.
If mirror glass is damaged:
Wear protective goggles and cut-proof gloves.
Risk of injury by flaking-off glass splinters.

IMPORTANT: Bring door mirror to room temperature to prevent catches from breaking off.

NOTE: Secure mirror glass (1) against falling out.
Cables for mirror heating are very short.
Press mirror glass (1) on side of car by hand to full extent.

Tape off mirror glass (1) with adhesive tape (2).

Unclip mirror glass (1) all round with special tool 00 9 317.

If necessary, disconnect associated plug connections.

Remove mirror glass (1).

Fig 1: Removing Mirror Glass Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs (1) must not be damaged.

Fit mirror glass (2) with retaining lugs (1) flush on mirror adjusting drive and clip into place.

Ensure correct locking.

Check function.

Fig 2: Identifying Retaining Lugs And Mirror Glass

Courtesy of BMW OF NORTH AMERICA, INC.