51 32 154 Adjusting left or right front door window glass

WARNING: This page is about a different variant/trim than selected.

Special tools required:

51 0 350
51 0 351
51 0 352
51 3 010
51 3 080
51 3 240

Requirements for correct adjustments:

Front door CORRECTLY ADJUSTED .
Car must stand on its wheels

To adjust, a special tool 51 0 350 is required.

Ideal setting, window height:

Open door, engage special tool 51 3 080 on door window glass and close door.

Measure retraction depth at positions (1 to 3).

Dimensions:

1 = 5 ± 1 mm

2 = 5 ± 1 mm

3 = 4.5 ± 1 mm

NOTE:

Passenger side:

Top edge of window must be flush with top edge of fixed Clubdoor window.

Fig 1: Measuring Retraction Depth Using Special Tool (51 3 080)

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting window height:

Remove OUTER WINDOW CAVITY COVER STRIP

IMPORTANT: Tape off door in working area of special tool 51 3 240.

Feed in special tool 51 3 240 between supports (1) and place on nut (2) in between.

Slacken nut (2) with special tool 51 3 240 until door window can be moved.

Fig 2: Adjusting Retraction Depth Using Special Tool (51 3 240)

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 51 3 010 and adjust door window.

Check adjustment. If necessary, repeat procedure.

Tightening torque 51 32 1AZ

Initialize POWER WINDOW .

Ideal setting, preload:

NOTE: Pre-tension is checked with installed window cavity cover strip. Special tool 51 0 351 creates gap for measuring pretension. No force must be exerted on the door or door window glass during measurement.

Insert special tool 51 0 351 in rotary striker of door lock and press in up to end stop. Window glass then travels to uppermost position. Carefully leave door slightly open until magnet makes contact with striker.

Fig 3: Measuring Pretension Using Special Tool (51 0 351)

Courtesy of BMW OF NORTH AMERICA, INC.

Slide special tool 51 0 352 at distance (B) to door window glass side edge into seal (1) and measure dimension (A) to outside edge of door window glass (2).

Dimension (A) with window cavity cover strip:

A = 36 ± 2 mm

B = 10 mm

Fig 4: Measuring Dimension To Outside Edge Of Door Window Glass Using Special Tool (51 0 352)

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting pretension:

Lever out caps (1).

Slacken screws (2).

Adjust preload by moving window lift rail (3).

Check adjustment, repeat procedure if necessary.

Fig 5: Moving Power Window Rail

Courtesy of BMW OF NORTH AMERICA, INC.