36 10 713 Checking one road wheel on balancing machine for face and radial runout (wheel removed)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

36 1 030 . See WHEEL AND TIRES - SPECIAL TOOLS -- CLUBMAN .
36 1 031
36 1 032
36 1 033
36 1 034
36 1 035
36 1 036

Necessary preliminary tasks:

Remove wheel.

Mount wheel in balancing machine.

To avoid retooling errors, fit the wheel on the balancing machine in the same way as it is also fitted on the car (valve position facing down).

Fig 1: Identifying Wheel Weight Balancing Machine

Courtesy of BMW OF NORTH AMERICA, INC.

Use suitable wheel centering element supplied with corresponding balancing machine.

Basic flange
Wheel centering element
Type flange
Clamping nut

Also refer to section on WORKSHOP EQUIPMENT .

Fig 2: Identifying Basic Flange, Wheel Centering Element, Type Flange And Clamping Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 36 1 030 for testing.

Special tool 36 1 030 consists of:

Stand 36 1 031
Post with clamp 36 1 032
Holder with clamp 36 1 033
Clamp 36 1 034
Measuring roller 36 1 035
Dial gauge 36 1 036

Fig 3: Identifying Special Tools
Courtesy of BMW OF NORTH AMERICA, INC.

Position special tool 36 1 030 on tire tread.

Turn wheel by hand and measure max. radial tire runout.

NOTE: Measuring device must be vertical to tire tread.

Fig 4: Checking Radial Tyre Runout With Special Tool 36 1 030

Courtesy of BMW OF NORTH AMERICA, INC.

Position special tool 36 1 030 on tire side wall.

Turn wheel by hand and measure max. lateral tire runout .

NOTE: Measuring device must be vertical to tire side wall.
Never measure on printed text on tire!
If necessary, check disc wheel (rim) for radial and face runout .

Fig 5: Checking Lateral Tyre Runout With Special Tool 36 1 030

Courtesy of BMW OF NORTH AMERICA, INC.