13 62 010 Removing and installing/replacing fuel differential-pressure sensor (N12)

Necessary preliminary tasks: 

• Remove INTAKE FILTER HOUSING 
• Installation location: On intake air manifold, left side.

Unlock plug (1) and remove.

Release screw.

Pull differential pressure sensor (2) out of intake air manifold.

Installation: 

• Check sealing ring, replace if necessary.
• Tightening torque 13 62 1AZ
  Fig 1: Differential Pressure Sensor And Plug

  Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check stored fault messages.

Now clear the fault memory.