33 31 011 Replacing rear axle support

WARNING: This page is about a different variant/trim than selected.

NOTE: When replacing side member or cross-member:
Replace self-tapping screws for mounting rear axle carrier on side member / cross-member.

Necessary preliminary tasks:

Remove rear axle carrier .

Installation:

Use previous rear axle carrier as a template for modifying or replacing small parts.

Fig 1: Identifying Rear Axle Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Bleed braking system . See BRAKE TESTING AND BLEEDING .
Perform chassis alignment check . See 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION or 32 00 155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .

IMPORTANT: If the pedal support is removed or slips before the brake lines are connected, it will be necessary to bleed the brake system at front and rear!