33 32... Replacing left or right trailing arm bracket
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove trailing arm with bracket .
IMPORTANT:
When replacing trailing arm:
Replace self-tapping screw.
Before installing the trailing arm, tap a thread in the trailing arm with the new screw.
Replace self-tapping screw.
Before installing the trailing arm, tap a thread in the trailing arm with the new screw.
Release screw (1) and remove bracket (2).
Installation:
Tighten down screw in normal position.
Tightening torque 33 32 4AZ.
After installation:
- Perform chassis alignment check . See 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION or 32 00 155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .