32 00... Chassis/wheel alignment check procedure
WARNING: This page is about a different variant/trim than selected.
CHASSIS AND WHEEL ALIGNMENT PROCEDURE CHART
| Check adherence to test conditions | ||
| I V |
||
| Position vehicle on measuring stand | ||
| I V |
||
| Measure vehicle ride height | OK -> | Carry out chassis/wheel alignment check without load |
| Read off setpoint value in KDS Tolerance -20 / +40 mm per wheel permissible Difference between left / right max. 10 mm permissible |
||
| Not OK / no data I V |
||
| Move vehicle into normal position | ||
| Introduce load and measure ride heights | ||
| Read off setpoint value in KDS Tolerance ± 10 mm per wheel permissible Difference between left / right max. 10 mm permissible |
Not OK -> | |
| OK I V |
Check suspension for damage, repair if necessary | |
| Move vehicle into design position | <- Not OK | |
| Add/distribute weights and measure ride heights | ||
| Read off setpoint value in KDS Tolerance ± 2 mm per wheel permissible Difference between left / right max. 2 mm permissible |
||
| I V |
||
| Carry out chassis/wheel alignment check with DIN load |