31 35 000 Removing and installing/replacing front stabilizer
WARNING: This page is about a different variant/trim than selected.
WARNING:
Danger to life!
Mount securing fixture for vehicle on lifting platform to prevent the vehicle from slipping off or tilting down.
Mount securing fixture for vehicle on lifting platform to prevent the vehicle from slipping off or tilting down.
Necessary preliminary tasks:
- Lower front axle support . See 31 11 506 Lowering/raising front axle carrier (universal lifter) or 31 11 506 Lowering/raising front axle carrier (special tool SWZ00-2040) .
Release nut (1); if necessary, grip dihedron (2) or hexagon socket.
Installation:
Replace self-locking nut.
Tightening torque 31 35 1AZ .
Release left and right screws (1).
Remove stabilizer (2) from control arm bracket.
Installation:
Replace rubber mount for stabilizer.
Tightening torque 31 35 3AZ .
After installation:
- Version with Dynamic Stability Control (DSC): Carry out steering angle sensor adjustment . See 61 31 996 CARRY OUT STEERING ANGLE SENSOR ADJUSTMENT .
NOTE:
Only cars with DSC are fitted with a steering angle sensor (integrated in the steering column switch cluster).