63 99 002 Replacing halogen bulb for high beam headlight on left

WARNING: This page is about a different variant/trim than selected.

WARNING: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

Unlock retaining tab (1) and remove protective cap (2) from headlight.

Installation note:

Protective cap (2) must be correctly engaged.

Check seal.

Replace protective cap (2), if applicable.

Fig 1: Identifying Headlight Protective Cap And Retaining Tab

Courtesy of BMW OF NORTH AMERICA, INC.

Release lock (1) and pull halogen bulb for high-beam headlight (2) out of headlight.

Disconnect plug connection (3) and remove halogen bulb for high-beam headlight (2).

Installation note:

Make sure halogen bulb for high-beam headlight (2) is correctly seated.

Fig 2: Identifying Headlight Halogen Bulb With Plug Connection And Lock

Courtesy of BMW OF NORTH AMERICA, INC.