61 31 029 Removing and installing/replacing roof operating unit
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Remove trims (1) in direction of arrow.
Installation:
Retaining lugs must not be damaged.
Unlock retaining lugs (1) with a suitable tool on both sides.
Remove roof operating unit (2) in direction of arrow.
Installation:
Retaining lugs must not be damaged.
Unlock plug connections (1) and disconnect.
Remove roof operating unit (2).
Installation:
Make sure roof operating unit (2) is correctly seated.
Replacement:
If necessary, remove BULBS .