63 12 870 Replacing ignition unit for left xenon headlight (with xenon bulb)

WARNING: This page is about a different variant/trim than selected.

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by qualified personnel.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

IMPORTANT: Ignition unit and xenon bulb are viewed as a single component and must not be separated.

Unlock retaining tab (1) and remove protective cap (2) from headlight.

Installation note:

Protective cap (2) must be correctly engaged.

Check seal.

Replace protective cap (2) if necessary.

Observe NOTES FOR REPLACING THE PROTECTIVE CAP .

Fig 1: Identifying Ignition Unit Protective Cap With Retaining Tab

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock spring wire clips (1).

Disconnect plug connection (2).

Remove ignition unit for xenon headlight (3) from headlight.

Installation note:

Make sure ignition unit (3) is exactly seated in headlight.

Fig 2: Identifying Xenon Headlight Ignition Unit With Spring Wire Clips And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.