33 52 100 Removing and installing rear left or right spring strut shock absorber
WARNING: This page is about a different variant/trim than selected.
NOTE:
Replacing the spring strut shock absorber is described in REMOVING AND INSTALLING/REPLACING REAR SHOCK ABSORBER .
Necessary preliminary work
- Remove REAR WHEEL .
only: R55, R56, R57
Remove lead for pulse generator (1) and brake hose (2) from spring strut.
Installation note:
Make sure rubber grommets are correctly seated.
Support trailing arm from underneath using a workshop jack.
IMPORTANT:
Secure spring strut against falling out.
Release screw (1).
Tightening torque 33 52 1AZ .
Installation note:
Blow out metal chips in thread of trailing arm with compressed air (caused when fitting self-tapping screw for the first time).
R60: Replace screw.
Release screws (1) and remove spring strut.
Tightening torque 33 52 2AZ .
Installation note:
Replace screws.
Installation note:
- Secure upper spring strut in body.
- Turn shock absorber to align trailing arm.