33 32 021 Replacing left or right trailing arm

WARNING: This page is about a different variant/trim than selected.

NOTE: Replace self-tapping screw for mounting bracket (with rubber mount) on trailing arm.

Necessary preliminary tasks

Remove TRAILING ARM WITH BRACKET
Remove PULSE GENERATOR INCL. LEAD

Modify WHEEL BEARING

Modify TRAILING ARM BRACKET

Fig 1: Identifying Trailing Arm

G05516309

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Perform chassis/wheel alignment check. See 3200150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 3200155 KDS WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD