25 11 300 Replacing shift cable assembly

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release clips on stop/holder (1).

Detach selector lever cable (2) from ball joint.

Fig 1: Identifying Stop/Holder, Selector Lever Cable And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Remove heat shield (1).

Fig 2: Identifying Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

Detach selector lever cable (1) from floor plate.

Fig 3: Identifying Selector Lever Cable

Courtesy of BMW OF NORTH AMERICA, INC.