25 11 071 Replacing knob for shift lever

WARNING: This page is about a different variant/trim than selected.

Pull gaiter (1) forwards at an angle.

Using a suitable tool, release retaining lugs of retaining ring (2).

NOTE:

Do not twist knob during removal as this would cause the turning lock in the knob to shear off.
Tug firmly to remove knob.

Installation:

Fit knob on shift lever, align and press on until it snaps noticeably into place.

Fig 1: Pulling Gaiter Forwards Angle
Courtesy of BMW OF NORTH AMERICA, INC.

Pull gaiter over shift lever knob.

Release retaining lugs (1).

Detach gaiter (2) from shift lever knob.

Fig 2: Identifying Retaining Lugs And Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Note installation position.

Distance between retaining lugs (1/2) differs in size.

Fig 3: Identifying Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.